Daily Bulletin

  • Written by Emily Jateff, Adjunct lecturer in archaeology, Flinders University

Finding shipwrecks isn’t easy – it’s a combination of survivor reports, excellent archival research, a highly skilled team, top equipment and some good old-fashioned luck.

And that’s just what happened with the recent discovery of SS Iron Crown, lost off the coast of Victoria in Bass Strait during the second world war.

Based on archival research by Heritage Victoria and the Maritime Archaeological Association of Victoria, we scoped an area for investigation of approximately 3 by 5 nautical miles, at a location 44 nautical miles SSW of Gabo Island.

Hunting by sound

We used the CSIRO research vessel Investigator to look for the sunken vessel. The Investigator deploys multibeam echosounder technology on a gondola 1.2 metres below the hull.

Multibeam echosounders send acoustic signal beams down and out from the vessel and measure both the signal strength and time of return on a receiver array.

What happens now we've found the site of the lost Australian freighter SS Iron Crown, sunk in WWII The science team watches the survey from the operations room of the CSIRO research vessel (RV) Investigator. CSIRO, Author provided

The receiver transmits the data to the operations room for real-time processing. These data provide topographic information and register features within the water column and on the seabed.

At 8pm on April 16, we arrived on site and within a couple of hours noted a feature in the multibeam data that looked suspiciously like a shipwreck. It measured 100m in length with an approximate beam of 16-22m and profile of 8m sitting at a water depth of 650m.

Given that we were close to maxing out what the multibeam could do, it provided an excellent opportunity to put the drop camera in the water and get “eyes on”.

Down goes the camera.

The camera collected footage of the stern, midship and bow sections of the wreck. These were compared to archival photos. Given the location, dimension and noted features, we identified it as SS Iron Crown.

The merchant steamer

SS Iron Crown was an Australian merchant vessel built at the government dockyard at Williamstown, Victoria, in 1922.

What happens now we've found the site of the lost Australian freighter SS Iron Crown, sunk in WWII SS Iron Crown afloat. South Australian Maritime Museum, Author provided

On June 4 1942, the steel screw steamer of the merchant vavy was transporting manganese ore and iron ore from Whyalla to Newcastle when it was torpedoed by the Japanese Imperial Type B (巡潜乙型) submarine I-27.

Survivor accounts state that the torpedo struck the vessel on the port side, aft of the bridge. It sank within minutes. Thirty-eight of the 43 crew went down with the ship.

This vessel is one of four WWII losses in Victorian waters (the others were HMAS Goorangai lost in a collision, SS Cambridge and MV City of Rayville lost to mines) and the only vessel torpedoed.

After the discovery

Now we’ve finally located the wreck – seven decades after it was sunk – it is what happens next that is truly interesting.

What happens now we've found the site of the lost Australian freighter SS Iron Crown, sunk in WWII A bathymetric map showing SS Iron Crown on the sea floor with its bow on the right. CSIRO, Author provided

It’s not just the opportunity to finally do an in-depth review of the collected footage stored on an external hard drive and shoved in my backpack, but to take the important step of ensuring how the story is told going forward.

When a shipwreck is located, the finder must report it within seven days to the Commonwealth’s Historic Shipwreck Program or to the recognised delegate in each state/territory with location information and as much other relevant data as possible.

Shipwrecks aren’t just found by professionals, but are often located by knowledgeable divers, surveyors, the military, transport ships and beachcombers. It’s no big surprise that many shipwrecks are well-known community fishing spots.

While it is possible to access the site using remotely operated vehicles or submersibles, we hope the data retrieved from this voyage will be enough.

It was only 77 years ago that the SS Iron Crown went down. This means it still has a presence in the memories of the communities and families that were touched by the event and its aftermath.

No war grave, but protected

Even though those who died were merchant navy, the site isn’t officially recognised yet as a war grave. But thanks to both state and Commonwealth legislation, the SS Iron Crown was protected before it was even located.

All shipwrecks over 75 years of age are protected under the Commonwealth Historic Shipwrecks Act 1976. It is an offence to damage or remove anything from the site.

What happens now we've found the site of the lost Australian freighter SS Iron Crown, sunk in WWII A drop camera view of the bow of SS Iron Crown with anchor chains. CSIRO, Author provided

This protection is enhanced by its location in deeper water and, one hopes, by the circumstances of its loss.

Sitting on the sea floor in Bass Strait, SS Iron Crown is well below the reach of even technical divers. So the site is unlikely to be illegally salvaged for artefacts and treasures.

Yet this also means that maritime archaeologists have limited access to the site and the data that can be learnt from an untouched, well-preserved shipwreck.

Virtual wreck sites

But, like the increasing capabilities for locating such sites, maritime archaeologists now have access to digital mapping, 3D modelling technologies and high-resolution imagery as was used for the British Merchant Navy shipwreck of the SS Thistlegorm.

You can move within the video.

These can even allow us to record shipwreck sites (at whatever the depth) and present them to the public in a vibrant and engaging medium.

Read more: VR technology gives new meaning to ‘holidaying at home’. But is it really a substitute for travel?

Better than a thousand words could ever describe, these realistic models allow us to convey the excitement, wonder and awe that we have all felt at a shipwreck. Digital 3D models enable those who cannot dive, travel or ever dream of visiting shipwrecks to do so through their laptops, mobiles and other digital devices.

Without these capabilities to record, visualise and manage these deepwater sites, they will literally fade back into the depths of the ocean, leaving only the archaeologists and a few shipwreck enthusiasts to investigate and appreciate them.

So that’s the next step, a bigger challenge than finding a site, to record a deepwater shipwreck and enable the public to experience a well-preserved shipwreck.

What happens now we've found the site of the lost Australian freighter SS Iron Crown, sunk in WWII SS Iron Crown alongside SS Hagen. National Library of Australia, Author provided

Authors: Emily Jateff, Adjunct lecturer in archaeology, Flinders University

Read more http://theconversation.com/what-happens-now-weve-found-the-site-of-the-lost-australian-freighter-ss-iron-crown-sunk-in-wwii-115848

Business News

A Guide to Finance Automation Software

When running a business, it is critical to streamline certain processes to maintain efficiency. Too much to spent manually on tasks can wind up being detrimental to the overall health of the organis...

Daily Bulletin - avatar Daily Bulletin

Top Tips for Cost-effective Storefront Signage

The retail industry is highly competitive and if you are in the process of setting up a retail store, you have come to the right place, as we offer a few tips to help you create a stunning storefront...

Daily Bulletin - avatar Daily Bulletin

How Freight Forwarding Simplifies Global Trade Operations

Global trade operations are becoming increasingly complex due to international regulations, customs procedures, and the sheer scale of global logistics. For businesses looking to expand internation...

Daily Bulletin - avatar Daily Bulletin